It will errace it's self after several starts if it's not disconnected again. If you disconnect the battery and hook it back, you will have code 13 which simply mean 'battery disconnect'. It just tells you it's the end of any codes the controller has. key cycled 3 times, light on for 3-4 seconds, then blinks 1 time, pause, 3 times, longer pause, 2 times ,pause 4 times, longer pause, then 5 times, pause 5 times the goes out. You could have a whole string of codes in the controler memory. Then the light blinks 3 times and goes out for about 3-4 seconds. light on for about 3-4 seconds then goes out for about 2 seconds and then blinks one time and goes out for 3 seconds this is for the no.1. The light will blink the codes like this.Ĭycle the key three times and leave on on the third time. If the check engine light was on when you stopped the car, then there is at least one code in the controler. The check engine light will be on and will then go off and then on again according to the codes the engine controler happens to have in it. Turn the key to run then off, back to run, then off, then to run and leave it on. The van hasn't produced the engine light since. When it was completely dry I reinstalled the EGR solenoid on the van making sure I used ALL NEW GASKETS. I suggest just cleaning the valve and plunger ports, etc. I took mine "completely apart" after I did this I dont recommend to do this again, you can damage the coil inside if you're not cafefully. I took the EGR solenoid off from the engine and took it apart (reall carefully) and cleaned it thouroughly with a spray carbuerator cleaner. and another gasket that goes between the stand pipe and where it connects to the plastic valve intake area cover on top of the engine. one gasket that goes between the EGR valve solenoid and the small stand pipe. The van didn't seem to drive any different but this is what I did and I haven't seen the light come on since.įirst I went to the dealer ( you can get these parts from a auto parts house also) and bought the 3 gaskets total.for the the EGR solenoid vavle assembly where it bolts on to the engine ( that gasket was made from metal), NOTICE AN INDENTATION IN THE METAL GASKET WHEN YOU TAKE IT OFF,YOU WILL WANT TO PLACE THE NEW GASKET IN THE SAME DIRECTION. If my memeory serves me correct, I believe this was the same code that I got on time. SOURCE: 2005 grand caravan error code P0400 egr valve chk/ performance
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |